Browse system: Brakes & wheel end

Ford Fusion/Mercury Milan · Buyer's guide

2010–2012 Fusion/Milan Front Wheel Bearings: Separate Hub and Bearing

US 2010-2012 Ford Fusion/Mercury Milan; exact engine, transmission, drivetrain, position and package boundaries in guide

Current seller options

WHERE TO BUY

Open an exact listing, then confirm fitment, stock, price, and shipping with the seller before ordering.

Seller links checked . Prices and availability can change.

What you need to know

The reviewed US 2010–2012 Fusion and 2010–2011 Milan conventional sedan front repair uses a separate hub and bearing architecture.6E5Z-1104-BA is the referenced front hub with an ABS tone-ring provision in the OEM record;3M8Z-1215-A is the bearing reference. They are not two names for a complete bolt-on hub-and-bearing package. This guide covers 2.5L and 3.0L conventional models plus Ford Fusion Sport 3.5L, with exact VIN, drivetrain, transmission, and front position verification. Hybrid is outside the qualified purchase scope. An AWD rear-bearing application appearing on the bearing's broad product page does not turn a rear knuckle into a front replacement.

OEM numbers

6E5Z-1104-BA | 3M8Z-1215-A

Supersession

6E5Z-1104-BA follows 6E5Z-1104-AA/HUB-128 service references in the reviewed catalog.3M8Z-1215-A follows F32Z-1215-A. These are separate component histories, not a chain from the hub to the bearing. A similarly numbered 6E5Z-1104-AB entry was not qualified as an interchangeable alternative here. The ABS-related distinction matters: suffix letters and sensor-system details should not be discarded when comparing parts.

Fitment

The reviewed US 2010–2012 Fusion and 2010–2011 Milan conventional sedan front repair uses a separate hub and bearing architecture.6E5Z-1104-BA is the referenced front hub with an ABS tone-ring provision in the OEM record;3M8Z-1215-A is the bearing reference. They are not two names for a complete bolt-on hub-and-bearing package. This guide covers 2.5L and 3.0L conventional models plus Ford Fusion Sport 3.5L, with exact VIN, drivetrain, transmission, and front position verification. Hybrid is outside the qualified purchase scope. An AWD rear-bearing application appearing on the bearing's broad product page does not turn a rear knuckle into a front replacement.

Aftermarket options

Have the installer decide whether the existing hub and knuckle can be reused after inspection. A bearing-only quote can be incomplete if the hub's bearing surface is damaged or the knuckle bore is unsuitable. Ask whether the proposed aftermarket package includes a hub, bearing, retaining components, or merely one of those pieces. Check the ABS ring and the manufacturer's exact front application rather than buying an assembly from a photograph. Labor for a pressed bearing is different from swapping a bolt-on rear unit, so compare complete repair quotes with the same contents. Confirm the diagnosed side, but do not assume both front sides require replacement solely because the catalog requires two for a complete vehicle. One product quantity can mean one wheel, not one axle.

Before you buy

Noise or an ABS warning is not a sufficient diagnosis by itself; inspect wheel play, sensor wiring, tires, and related components as appropriate. A confirmed unsafe bearing needs prompt repair. Correct pressing support and axle-nut tightening are essential and come from vehicle service information. Availability, price, and package contents must be rechecked on the exact current seller page before purchase.

Research and fitment sources