Browse system: Steering & suspension

Chevrolet Uplander · Buyer's guide

2008 Chevrolet Uplander FWD front lower arms: left and right assemblies

US 2008 Chevrolet Uplander; exact engine, gearbox, axle, side and equipment gates in guide

Current seller options

WHERE TO BUY

Open an exact listing, then confirm fitment, stock, price, and shipping with the seller before ordering.

Seller links checked . Prices and availability can change.

What you need to know

The reviewed front lower control arms are for a US 2008 Chevrolet Uplander 3.9L V6 with automatic transmission and front-wheel drive. This includes the actual gasoline or flex-fuel engine identity after VIN confirmation, not an earlier all-wheel-drive or 3.5L application. Establish the failed corner and arm before ordering. On the US vehicle, left is the driver side and right the passenger side. A knuckle, front strut or rear link shown in the same broad suspension diagram is not another version of the selected lower arm.

OEM numbers

15218621 | 15218622

Supersession

15218621 identifies the reviewed front lower left assembly; 15218622 identifies the separate right assembly. The independent year-specific OEM dealer diagram explicitly describes both as without AWD and distinguishes their sides. The exact product pages corroborate the assembly identities. Do not treat them as successive revisions or interchangeable quantities of one arm. No service-number conversion to an older AWD arm is implied. An alternate seller using a shared GM minivan heading still needs to establish the correct side, factory driveline and original application.

Fitment

The reviewed front lower control arms are for a US 2008 Chevrolet Uplander 3.9L V6 with automatic transmission and front-wheel drive. This includes the actual gasoline or flex-fuel engine identity after VIN confirmation, not an earlier all-wheel-drive or 3.5L application. Establish the failed corner and arm before ordering. On the US vehicle, left is the driver side and right the passenger side. A knuckle, front strut or rear link shown in the same broad suspension diagram is not another version of the selected lower arm.

Aftermarket options

The detailed dealer diagram identifies included front and rear bushings and a ball-joint component within the control-arm assembly. Confirm the actual delivered package and any required hardware on the invoice rather than assuming every nearby illustrated component comes with the arm. A bushing-only or ball-joint-only repair is a different scope and should be compared on its own labor and assembly requirements. One exact arm card is one side, not a pair. An independent dealer marks its left-arm offer unavailable; that research page is not a purchase button. The separately fresh-checked exact destinations provide the qualified seller paths.

Before you buy

Have wear, damage or alignment concerns localized before replacing a complete assembly. The correct load precautions, fastener renewal, tightening and alignment procedure should be established by the repairer before disassembly. This guide does not supply generic suspension torque values or imply that an arm will correct every pull or noise. Inspect the delivered side, joint and mounting arrangement before installation. Availability was observed at a specific review time, not reserved indefinitely. If the original suspension has been modified or the supplied contents differ, reconcile the order rather than accepting an incomplete or opposite-side product because it is easier to obtain.

Research and fitment sources

Supersede reviewed 6 unique research sources for this guide. 2 also appear above as a seller or official action and are not repeated here; 4 additional citations follow.

Research last verified .

  1. Chevrolet — 2008 chevrolet uplander owners
  2. Gmpartsgiant — oem 2008 chevrolet uplander control arm
  3. Gmpartsdirect — suspension hardware fasteners and fittings
  4. PartsGeek — llbbktj chevrolet uplander control arm and ball joint assembly